Single-story | through-wall flue kit (around roof overhang) | Rear Exit | Ø130

Single story | through-wall flue kit |

Rear Flue Exit | 130mm diameter

Single-story chimney flue kit for closed combustion stoves, for installation where the flue exits out through the wall to outside.

The full kit is made up of non-insulated (single wall) flues, 90-degree offset, T-Piece, a set of 45-degree offsets, cowl and wall support brackets.

The single skin flues are made of standard 304 stainless steel (mirror finish).

This option caters for installations with a short roof overhang – one which is not deep enough to allow flue go right through it but

wide enough to prevent flue going straight up without making contact with the hot flue pipe.

Therefore for this situation we use

2 x 45-degree offsets

to divert the flue around the roof eaves.

Often an additional short flue pipe is needed to insert in between the 2 x 45-degree offsets

Flue kit consists of :

1 x Ø 130 x 1000 mm

Single wall

“1st stage” flue pipe (crimped on both ends)

3 x Ø 130 x 1000 mm

Single wall

“2nd stage” flue pipes (crimped on one end only)

1 x Ø 130 x 500 mm

Single wall

“2nd stage” flue pipe (horizontal section)

1 x Ø 130 x 250 mm

Single wall

“2nd stage” flue pipe (in between 2 x45 offsets)

1 x Ø 130 x 90-degree offset

Single wall

1 x Ø 130 x

T-Piece

incl. end-cap

Single wall

2 x wall/ceiling plates , Ø 130 I.D to cover wall openings on both sides

2 x Ø 130 x

45-degree offsets, Single wall

1 x

Cyclone cowl

2 x wall support brackets

Technical Specifications :

304 high grade stainless steel for non insulated flues , bend and T-piece.

10 year warranty.